API 610 Pumps We Deliver

Fuglesangs AS | 23. jun 2021
6 minutter lesetid

Centrifugal pumps according to API 610.

  • Meet all API 610 requirements.
  • Seal interface meets the API 682 standard.
  • Mechanical seals and seal-systems as per API682
  • All relevant materials available, also NORSOK M-630, M-650.
  • Complete skids, packaged according to all customer’s requirements.
  • Mechanical completion
  • System Integration Testing at Fuglesang premises or at factory
  • Design fully according to NORSOK
  • Calculation, verification of mechanical integrity
    • Lifting operations
    • Static loads
    • Dynamic loads
    • Environmental loads
    • Accidental loads
  • Dynamic analysis
  • System
  • ATEX, Zone requirements.

All pump types according to API 610 designations available.

Pump type OH2 

Centreline-mounted, single-stage overhung pumps pump type OH2, with bearing housing to absorb all forces imposed upon the pump shaft and maintain rotor position during operation. These pumps are mounted on a baseplate and are flexibly coupled to their drivers.

Pump type OH2 API 685 (Magnetic drive)

Centreline-mounted, seal less magnetic drive pump, single-stage overhung pumps pump type OH2, with bearing housing to absorb all forces imposed upon the pump shaft and maintain rotor position during operation. These pumps are mounted on a baseplate and are flexibly coupled to their drivers.

Pump type OH3 

Vertical, in-line, single-stage overhung pumps with separate bearing brackets pump type OH3. These pumps have a bearing housing integral with the pump to absorb all pump loads. The driver is usually mounted on a support integral to the pump. The pumps and their drivers are flexibly coupled.

Pump type OH5

Close-coupled, vertical, in-line, single-stage overhung pumps OH5. Close-coupled pumps have their impellers mounted directly on the driver shaft.

Pump type OH6

High-speed, integral, gear-driven, single-stage overhung pumps, type OH6. These pumps have a speed-increasing gearbox integral with the pump. The impeller is mounted directly to the gearbox output shaft. There is no coupling between the gearbox and pump; however, the gearbox is flexibly coupled to its driver. The pumps may be oriented vertically or horizontally.

Pump type BB1

Axially split, one- and two-stage, between-bearings pumps type BB1.

Pump type BB2 

Radially split, one- and two-stage, between-bearings pumps type BB2.

Pump type BB3 

Axially split, multistage, between-bearings pumps type BB3.

Pump type BB4 

Single-casing, radially split, multistage, between-bearings pumps, type BB4. These pumps are also called ring-section pumps, segmental-ring pumps, or tie-rod pumps.

Pump type BB5 

Double-casing, radially split, multistage, between-bearings pumps (barrel pumps), type BB5.

Pump type VS1

Wet pit, vertically suspended, single-casing diffuser pumps with discharge through the column, type VS1.

Pump type VS2 

Wet pit, vertically suspended, single-casing volute pumps with discharge through the column, type VS2.

Pump type VS3 

Wet pit, vertically suspended, single-casing axial-flow pumps with discharge through the column, type VS3.

Pump type VS4

Vertically suspended, single-casing, volute, line-shaft-driven sump pumps type VS4.

Pump type VS6 

Double-casing, diffuser, vertically suspended pumps, type VS6.

Pump type VS7 

Double-casing, volute, vertically suspended pumps pump, type VS7.